Bilstein 6112 Front Shock & Spring Kit 47-323841, 2021-26 Ford F-150 4WD, Without CCD

Bilstein B8 6112 Front Shock and Spring Kit

Bilstein 47-323841 pairs two 60mm front shock absorbers with matched coil springs for compatible 2021–2026 Ford F-150 4WD applications without Continuously Controlled Damping (CCD). This is a front-only kit, not a rear shock package or a four-shock set.

Included components

• One 47-323841 front kit — provides application-specific front lift: 0–2.5 inches on listed non-Tremor 3.5L EcoBoost and 5.0L applications, 0.4–2.4 inches on listed 2.7L EcoBoost applications, 0–1.9 inches on listed PowerBoost Hybrid applications, or 0–1.5 inches on listed Tremor applications
• Two 60mm front shock absorbers
• Two custom-matched cold-wound coil springs
• Two billet aluminum spring seats

Vehicle fitment and ride height

Bilstein's exact-part table lists compatible 2021–2026 F-150 configurations with engine-, year- and trim-specific conditions. The applicable rows specify without Continuously Controlled Damping. Check the exact vehicle in the manufacturer table before ordering; not every engine is listed for every trim and year.

Multiple snap-ring grooves allow spring-seat selection during assembly. The available front lift range depends on the exact application, so neither a universal 2.5-inch lift nor the generic 0–2.75-inch family range applies to every truck. Listed Tremor applications have a 0–1.5-inch range rather than the non-Tremor engine ranges.

This listing does not claim fitment for Raptor or CCD-equipped vehicles. Rear shocks and rear lift components are not included in the listed kit.

6112 design and assembly

The large 60mm digressive piston and matched springs provide application-tuned damping and front suspension support for on-road and off-road use. Select the spring-seat position using the instructions for the exact vehicle configuration.

This is a shock-and-spring component kit, not a confirmed preassembled coilover package with new upper mounts. Review the installation instructions for required assembly and original-component reuse before beginning work.

Manufacturer fitment and installation references

• Bilstein 47-323841 specifications and exact vehicle application table
• Bilstein front kit installation instructions (PDF)

Confirm the intended ride height and installation requirements before assembly. Do not assume compatibility with additional leveling spacers or other lift systems without manufacturer confirmation.